（毕业论文毕业设计）-Buck-Boost开关变换器的混杂建模与控制研究.docVIP

w Buck-Boost开关变换器的混杂建模与控制研究 （西南交通大学信息科学与技术学院，四川成都，610031） 摘要 运用混杂系统理论, 建立了Buck-Boost开关变换器的混杂自动机模型, 与传统的状态空间平均法相比该模型中没有任何假设或线性近似处理, 建模精度高, 可以对电力电子电路进行更好的分析与控制。分析了Buck-Boost变换器在负载变化的能量传输模式, 根据电感电流纹波与输出电流、电感平均电流的关系, 将开关变换器分为连续-完全电感供能模式(CCM-CISM)、连续-不完全电感供能模式(CCM-IISM)和不连续-不完全电感供能模式(DCM-IISM); 然后基于电路理论法给出了Buck-Boost开关变换器混杂控制边界选择综合方法和计算公式。基于Simulink和StateFlow的联合仿真结果证明了混杂控制算法的有效性。 关键词 混杂控制; 建模; Buck-Boost开关变换器; 混杂自动机; 完全电感供能模式; 不完全电感供能模式 中图分类号: TM46 Hybrid Modeling and Control for Buck-Boost Switching Converters Ma Hong-bo1 Feng Quan-yuan （School of Information Science Technology, SWJTU, Chengdu 610031,China） Abstract In this paper, the buck-boost switch converter is represented as a hybrid automaton model with three modes of operation. Comparing the state space average method and circuit average approach, the model is without any assumptions and linear approximation, which is more suitable to analysis and control for power electronic circuit. Meanwhile, a new hybrid control scheme is proposed for controlling dc–dc boost converter circuits. This algorithm divides buck-boost switching converter into three modes, i.e., CCM-CISM (continues conduction mode- Complete Inductor Supply Mode), CCM-IISM (continues conduction mode- Incomplete Inductor Supply Mode) and DCM-IISM (discontinues conduction mode- Incomplete Inductor Supply Mode) by comparing the inductor current ripple with difference between the inductor average current and the output current. The hybrid control synthesis method and calculation formulas of boost converter are given by the circuit theory approach. The hybrid automaton based control system is implemented using the state flow chart feature of MATLAB and extensive simulations are carried out to check the suitability of the algorithm. Numerical results clearly bring out the advantages and effectiveness of the proposed control law under varying line and load conditions. Key words Hybrid Control; Modeling；buck-Boost Switching Converters；Hybrid automaton；Co