原创力文档- 1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
- 2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
- 4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
- 5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
- 6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
- 7、VIP文档为合作方或网友上传，每下载1次， 网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
DESIGN OF A TWOCHANNEL SOLIDSTATECourse …一个双通道固态课程设计…
PAGE 1
PAGE 1
DESIGN OF A TWO-CHANNEL SOLID-STATE
CLASS-A AUDIO POWER AMPLIFIER
BY
WENG LOONG FOONG
DAVID NEO
ECE 345
In Seop Lee, TA
4-30-99
Team #47
ABSTRACT
A two-channel Class-A audio power amplifier was designed and operated with high fidelity and low distortion. The amplifier performs amplification of a line signal and outputs through an 8? load. The transistors are restricted to operation in the linear region to achieve greatest linearity. Biasing was done with a constant current source in a push-pull configuration to reduce the peak current needed for biasing to half. Using this circuitry, an efficiency of 39.7% was achieved, greater than the usual 20-25% of normal Class-A amplifiers. The maximum deviation of the gain frequency response was demonstrated to be within 1 dB in the 20Hz to 20kHz range. The distortion of the amplifier averaged around 2.5% over the said frequency range.
1. Introduction
The project involved designing and constructing a high-fidelity Class-A amplifier. Design was solid-state based and biased with a constant current source in a push-pull configuration. The final product is to be compatible for use with any conventional audio input, which has been pre-amplified, and output is to be coupled through conventional 8? speakers.
The choice of solid-state over vacuum tubes is largely because solid-state amplifiers are more dynamic in nature, and are hence better able to amplify frequencies in the low to mid-range, and because solid-state amplifiers are more cost effective A good pair of matched MOSFETs will cost approximately $20 whereas a matched pair of tubes can run into hundreds of dollars. and have lower maintenance
A good pair of matched MOSFETs will cost approximately $20 whereas a matched pair of tubes can run into hundreds of dollars.
Depending on usage, tubes need to be changed once every one to two years while solid-state amplifiers are relatively maintenance free.
Overview of Output Classifications
Output stages of amplifi
文档评论（0）