多层介质结构椭圆函数型带通滤波器设计研究-电磁场与微波技术专业论文.docxVIP

万方数据 万方数据 Abstract Microwave filters can be designed using distributed-elements or lumped-elements. The distributed-element filters are featured with good performance and large size while the lumped-element filters are featured with tiny size and average performance. Moreover, the increasing working frequency makes the design of lumped-element filers harder and harder. As a result, it is the constant theme to design filters with high performance and tiny size. The multilayer substrate structure is a promising way to realize this goal because the designer can design tiny lumped-capacitors and lumped-inductors in multilayer way. Therefore, the size is not a problem anymore and the performance is focused on. Elliptic function bandpass filter, which has a high performance in selectivity, is suitable for designing in multilayer way because it is only composed of serial LC resonators or parallel LC resonators. In this thesis, elliptic function bandpass filter constructed on multilayer substrates is fully discussed and the contents are listed as follows: Starting from the third-order elliptic lowpass prototype, the final bandpass filter circuit model is obtained and each parameter is analyzed to determine their influences on overall performance. The way of tuning bandwidth is discussed. Meanwhile, it is found that when fixing the resonate frequency of all resonators and changing the capacitances in the scale of ±20% (inductances are also changed to keep the resonate frequency), the overall performances still meet the requirements. Based on the circuit model, a new compact multilayer substrate structure layout is proposed. Meanwhile, the sizes of each component are analyzed to determine their influence on overall performance. It is also found that when fixing the resonate frequency of all resonators and changing the sizes of capacitances in the scale of ±20% (inductances are also changed to keep the resonate frequency), the overall performances still meet the requirements,