冲击水浴除尘器中含尘气体穿越液池多相流动特性研究-工程热物理专业论文.docxVIP

沉降主通道反折的趋势。因下降管中心处颗粒沉降最快，下降管中心处颗粒首先与 液池底部接触并开始铺展。颗粒在液池底部最后呈中间低两边高的分布。 关键词：冲击水浴除尘器；含尘气体；多相流；数值模拟 Abstract The impact water bath dust removal technology is one of the import technology of wet dust removal process,It is widely applied in the field of flue gas dust and coal gasification synthesis gaswashing.There are a lot of complex processes include multiphase flow,heat and mass transfer separation in the impact water bath dust remover.And the relevant rules and mechanisms are still not complete.So,the primary research method will be both experimental and numerical simulation,the study is around the complex multiphase flow of dusty gas passing through the liquid pool in the impact water bath dust remover,probe into the inherent mechanism.In this paper,the main research contens include the following aspect. Design and construction the impact water bath dust remover test bench.With this test bench we visual study the submerged jet erosion behavior in the impact water bath dust remover by a high speed camera. The study found that the impinging dent’s the development experiences four stages: dent forming, dent growing, dent growing stagnation and dent motion.In the stage of dent growing stagnation,the dent is approximately spherical.Extract the information of depth of the dent,we found that the depth of the dent rising to the wave crest begin and going down to the trough, it is repeating the process above. Sampling the suspension liquid pool of obtained under different conditions, the axial distribution of solid holdup were. The study found: the smaller particle more easily suspended in the liquid tank; effect of sedimentation velocity of particle size is larger particles in the liquid pool by the phase velocity is obvious; the larger particle size or smaller, particles are not easy staying on the surface, the particle size of particles on the surface of the liquid medium is more likely to stay; gas the impact of liquid pool phase velocity is larger, the role of fluid re