高速铣削加工淬硬模具模具钢的优化策略--外文翻译.pdf

Journal of University of Science and Technology Beijing Materials Volume 13, Number 3, June 2006, Page 240 Optimization strategy in end milling process for high speed machining of hardened die/mold steel Ying Tang Mechanical Engineering School, University of Science and Technology Beijing, Beijing 100083, China (Received 2005-02-21) Abstract: An optimization strategy for high speed machining of hardened die/mold steel based on machining feature analysis was studied. It is a further extension of the previously presented study on the thermal mechanism of end milling and constant cutting force control. An objective function concerning machining cost and associated optimization algorithm based on machining time and cutting length calculation was proposed. Constraints to satisfy specific machining strategies when high speed machining the hardened die/mold steel, trochoid tool path pattern in slot end milling to avoid over-heat and feed rate adaptation to avoid over-load, were also discussed. As a case study, the tool selection problem when machining a die part with multiple machining features was investigated. Key words: optimization algorithm; hardened die/mold steel; machining cost; machining feature 1. Introduction This paper is organized as follows: an objective function concerning machining cost and its associated The introduction of advanced cutting tools like optimization algorithm is proposed in Section 2, fol- AlTiN-coated micro-grain carbide end mill since the lowed by a case study to use the proposed algorithm for 1990s has changed