大曲率主管的X型圆钢管和圆钢管混凝土节点受弯性能试验-研究.pdf

Abstract Abstract In this paper, starting from the experiment, experiment was conducted to study the flexural performance of X type circular steel tube with large curvature and circular concrete filled steel tubular joint chord of in-plane and out plane. And on this basis through ABAQUS finite element simulation and parameter analysis, inspected node bending case stress performance, failure mode, effect of stress and strain distribution, the static ultimate bearing capacity and geometric parameters on the ultimate bearing capacity of the nodes in the out of plane and in-plane, focuses on the chord of radius of curvature of X type node flexural performance influence. Firstly, this paper studied the static performance of X type circular steel tube with large curvature and circular concrete filled steel tubular joint chord in-plane and out plane flexural properties. Each of the 16 X-joint of in -plane bending nodes and 16 X-joint of out -plane bending for 2 groups of static test. Each group of specimens were divided into 4 groups, separately on the X type node with large curvature chord at different geometrical parameters and competent to fill stress performance, failure mode, ultimate bearing capacity of concrete under static conditions are investigated, expecially on the effect of chord curvature radius. The test results shows: For the X type of in-plane bending nodes, when the chord relatively flat, the curvature of chord of X type node was not affected much of in-plane bending bearing capacity; when the curvature of chord reaches a critical value, decreased in-plane bending bearing capacity of X type node. With the increase of β, in-plane ben