几何公差控制角度偏差及角度公差分析.PDFVIP

V ol N o Chinese Journal of Engineering Design Jun doi issn X j T G A X Angle deviation control using geometric tolerance and angle tolerance analysis X U Xusong W U Dehui College of M echanical Engineering Jiang su U niversity of T echnology Changzhou China Key Laboratory of Advanced M anufacturing T echnology of Zhejiang Province School of M echanical Engineering Zhejiang U niversity Hangzhou China BOSC H Pow er T ools China Co L td Hangzhou China Abstract Aiming at the problem s that angle size tolerance cannot control the angle deviation be tw een tw o planes and the angle deviation may be out of control w hen using geo metrical tolerance the tangent f eature sy m bol f or toleranced f eature w as introduced When the geo metric tolerance w as used to control the angle deviation betw een the toleranced surf ace and the datum the tangent f eature sy mbol w ould be added to the toleranced f eature T he conversion method betw een geo metric tolerance and angle tolerance w as given Aiming at the problem of the accum ulation calcu lation of angle deviation betw een tw o planes in assembly lay er the illustration of angle dimension chain and the accumulation calculation method of angle dimension chain deviation w ere studied f or the part s w hich had been assem bled Finally taking the electric w ood cutting machine as an ex ample the angle accum ulation deviation of the relative f eatures of each part w as controlled by ge o metric tolerance to meet the desi