钢铝复合板热轧复合变形规律.PDFVIP

第 19 卷第 4 期 中国有色金属学报 2009 年 4 月 Vol.19 No.4 The Chinese Journal of Nonferrous Metals Apr. 2009 文章编号：1004-0609(2009)04-0644-05 钢/铝复合板热轧复合变形规律 李民权，蒋福林，张 辉，李落星 (湖南大学 材料科学与工程学院，长沙 410082) 摘 要：采用弯曲实验、金相和扫描电子显微镜，研究轧制温度、变形量对钢/铝复合板热轧复合的结合强度、界 面和厚比分配的影响。结果表明：在轧制温度低于 400 ℃时，弯曲次数随着预热温度的升高而增加，之后又逐渐 减少；轧制温度在 400 ℃时钢/铝复合板结合界面的结合强度最大；随着轧制温度的升高，铝层的压下量增加， 钢层的压下量减小，致使两者压下量的差值增加；总的压下量越大，弯曲次数越多，结合界面和结合强度越好； 当总压下量为20%~30% 时，弯曲次数随压下量的增加而缓慢增加；当总压下量＞30%时，弯曲次数随压下量的增 加而快速增加；随着总压下量的增加，钢和铝的压下量成正比关系增加，变化趋势相同，组元压下量的差值随总 压下量的增加而减小，变形量趋于一致。 关键词：钢/铝复合板；热轧复合；结合强度 中图分类号：TG 115.9 文献标识码： A Deformation rule of steel/aluminum metal-laminate material during hot roll bonding LI Min-quan, JIANG Fu-lin, ZHANG Hui, LI Luo-xing (College of Materials Science and Engineering, Hunan University, Changsha 410082, China) Abstract: The effects of rolling temperature and reductions on the bonding strength, interface and distribution of thickness ratio of the steel/aluminum metal-laminate materials, which were prepared by hot-rolling process, were studied by using bending tests and metallographic microscopy and scanning electron microscopy. The results indicate that the number of bending increases with increasing rolling temperatures below 400 ℃ , whereas decreases after that. The maximum bond strength is obtained at 400 ℃. With increasing the rolling temperature, the rolling reduction of the aluminum laye