《门合页上盖注射模具设计及建模仿真》》-毕业论文.doc

PAGE 摘 要 本模具是门合页上盖的注射成型模具。它采用单型面分型，结构紧凑；采用点浇口，顶出时，由推杆和斜导柱共同作用下将制品顶出，完成制品内侧凹的抽芯；塑件由模具动模上的水道以两支回路分别冷却。通过采用典型的型芯结构、多弹簧顶出复位系统，使得模具的使用寿命和可靠性大大提高。经过在实践中不断优化加工工艺、控制加工精度和改进配模技术，从而大大缩短了配模时间和模具的制造周期，提高了劳动生产效率，降低了模具的制造成本。 毕业计论文主要由两部份组成：注射模具的工作原理及其结构设计；模具各部份尺寸计算。 关键词：注射模具 门合页上盖 注射 冷却  Abstract This is the door hinge cover mold injection mold. It uses a single surface type, compact structure; using point gate, top out, by putting and under the action angle pin out of the top products, finished products, concave inner core pulling; plastic parts from the mold dynamic model Two loops on each channel to cool. By using a typical core structure, the top of the spring to reset the system more, making the mold life and reliability are increased. In practice, continuous optimization through process control and improvement of precision with modeling techniques, thus greatly reducing the distribution model and mold manufacturing cycle time, improve labor productivity, reduce manufacturing costs of the mold. Total graduate thesis consists of two parts: the working principle of injection molding and structural design; die size of each part of the calculation. Key words: Injection mold; Door hinge cover ; Injection; Cooling PAGE 目 录 TOC \o 1-3 \h \u HYPERLINK \l _Toc24577 摘 要 PAGEREF _Toc24577 I HYPERLINK \l _Toc32677 Abstract PAGEREF _Toc32677 II HYPERLINK \l _Toc17423 第1章 绪 论 PAGEREF _Toc17423 1 HYPERLINK \l _Toc11075 1.1前言 PAGEREF _Toc11075 1 HYPERLINK \l _Toc15618 1.2 模具发展现状及发展方向 PAGEREF _Toc15618 1 HYPERLINK \l _Toc17314 1.2.1国内外注塑模具的发展现状 PAGEREF _Toc17314 1 HYPERLINK \l _Toc1627 1.2.2国内外注塑模具的发展趋向 PAGEREF _Toc1627 2 HYPERLINK \l _Toc23508 1.3 本课题的内容和具体要求 PAGEREF _Toc23508 3 HYPERLINK \l _Toc24112 1.3.1 本课题的内容 PAGEREF _Toc24112 3 HYPERLINK \l _Toc31671 1.3.2 具体要求 PAGEREF _Toc31671 3 HYPERLINK \l _Toc28284 第2章 零件材料分析及方案论证 PAGEREF _Toc28284 4 HYPERLINK \l _Toc18573 2.1 零件的材料及材料的特性 PAGEREF _Toc18573 4 HYP