单相统一电能质量控制器的分析-电气工程专业论文.docx

哈尔滨工业大学工学硕士学位论文 哈尔滨工业大学工学硕士学位论文 - - II - Abstract Unified Power Q ualit y Controller comb ines the funct ion of the voltage compensator and current compensator, which can control the mult iple power quality problems. UPQ C has become the emphasis of power control field for it ’s excellent compensation performance . The single- phase UPQ C has been researched in this paper. Firstly, the topology and working principle of UPQC has been researched, the main circuit structure and mathemat ical model was established. The LCL filter was introduced into the parallel section of UPQC, and the ma in device parameters had been designed. Secondly, the single-phase power detection methods had been studied in this paper. Based on the research on single-phase voltage and current detections on the basis of the instantaneous reactive power theory, the single-phase voltage detection method which can detect voltage sags and swells of single- phase system was proposed. For reducing the calculat ion of the single-phase current detection, the detection based on the trigono metric function was proposed, and its modified detection method improved the detection accuracy. Moreover, the modulation strategy for single-phase has been studied on, the single-phase SVPWM method was applied in the paper. The switching mode was optimized, which can reduce the switching losses. Finally, the UPQC control strategies had been studied. The double- loop current control strategy based on PR outer loop was proposed, with comparing the tradit ional control strategies applied in UPQC. However the compound control which combined the PI control and repetit ive control can overcome the shortcomings of PI control method, its calculation is much huge and system is much complex. Then the PR control was proposed, which can achieve good effect with sma ll amount of work. The PR control method had been improved by introducing the inner feedback current of the capacit ive. The double- loop current control strategy based