磁电机自动化检测系统的设计与开发-机械工程专业论文.docx

华中科技 大学硕士 学 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract Magneto is a small alternator, the magnetic field of which is generated by the permanent magnet. It is the ignition power supply in gasoline engine ignition system. Its main purpose is to generate high voltage and assigned to the cylinder spark plug, to provide ignition energy so as to make the engine work for ignition system. To determine the performance index of magneto product quality mainly includes secondary open-circuit voltage, ignition advance angle, cutoff frequency and the ignition energy. This topic originates from the actual application requirement in magneto production line of an Electrical Appliance Co. Ltd in Zhejiang Province. The main task is to detect the process of magneto product, and to design a real-time detection system that can simultaneously detect the two magneto products, to detect the performance parameters of magnetic motor, and assist to add the corresponding execution mechanism to realize the detection process. The detection of the original enterprise workshop is mainly use oscilloscope to observe secondary open-circuit voltage, switch ignition by manual, and read the ignition spark in the discharge position dial to judgment ignition advance angle from the rotation scale plate. The detection parameter is few, the form is single, and only one product can be detected in one time. The efficiency is low, and the intensity is high. This tester is used in double station, one rotor with two stators. In each detection process, two products can be detected simultaneously in detection station, while the detected products are replaced in another station. The pneumatic control is used to realize the whole products detection process for automation, improve the detection efficiency, reduce the labor intensity. The system uses TMS320FS2812 designed by TI Co. as the main control chip, with sensor and AD data acquisition module to collect the signal, and complete the processing of voltage signal and th