单级PFCLED驱动电源的研究与设计-电路与系统专业论文.docx

论文题目:单级PFC LED驱动电源的研究与设计 专 业:电路与系统 硕 士 生:张 雪 (签 名) 指导教师:刘树林 (签 名) 摘 要 随着能源成本持续上升，采用更高效、更低成本的光源引起了极大的关注，LED? 其环保、寿命长、光电效率高等众多优点，近年来在市电照明市场上的比重越来越大， 带动了具有功率因数校正(PFC)功能的驱动电源的发展。由于单级PFC的体积小，成 本低，可靠性好，而且结构简单，为了达到提高功率因数的目的，本文设计了一款单级 PFC LED驱动电源。 基于单级PFC的工作原理，分析了各种变换器拓扑的优缺点及应用场合，指出单端 反激变换器更具优势:分别比较了有源功率因数校正三种工作模式及三种控制方式的优 缺点，进一步指出主电路应工作在连续导电模式下的平均电流控制模式:详细分析了连 续导电模式单级PFC反激开关变换器的工作原理、稳态特性后，给出了输入电流与输入 电压的关系:同时对极限参数和输出电压纹波进行了详细的分析，为主电路的设计提供 了理论依据。综合?上分析，得出了连续导电模式下基于反激变换器的单级PFC电路设 计的一般方法。基于该设计方法，采用PFC控制器NCP1652研制了一台基于反激变换器 的单级PFC电路试验样机，其工作电压为90VAC~265VAC、输出为48V/2A，经实验测试， 该设计电路工作正常，且功率因数达到了0.98。 该电路基本消除了谐波对电网的污染，提高了功率因数，满足 IEC61000-3-2 谐波标 准。实验结果验证了理论分析的正确性和可行性，表明了该电路具有较强的实用性和优 越性，对单级 PFC 技术有普遍的指导意义。 关 键 词:LED 驱动电源:单级 PFC:反激变换器:CCM:NCP1652 研究类型:应用研究 Specialty: Circuit SystemName: Zhang Xue(Signature) Instructor: Liu Shulin(Signa Specialty : Circuit System Name : Zhang Xue (Signature) Instructor : Liu Shulin (Signature) ABSTRACT With the persistently rising in price of energy resources, it is meaningful to use higher efficiency, lower cost light source. For its advantages of environmental protection, long life and high efficiency, the proportion of LED is larger and larger, and the LED driver with the function of power factor correction(PFC) is developing as a result. The circuit using single-stage PFC technology is smaller, cheaper, Simpler and more reliable than the two-stage, so a signal-stage power factor correction power supply of LED is designed to meet the purpose of improving the power factor. Based on the working principle of single-stage PFC, analyzes the advantages and disadvantages of various converter topologies and applications, and indicates hat flyback converter is better than the others; By comparing the three operating modes of converter and the three current control modes, respectively, Continuous Conduction Mode(CCM) and Average Current Control is selected. The working principle of CCM single-stage PFC flyback converter is Analyzed in de