《如何区分DDR的读写信号》课件.pptVIP

2008/3/31 Confidential 2005/5/25 最新の高速オシロスコープを支えるDSPとプローブ技術について 日本テクトロニクス株式会社 Method to separate Writes from Reads by Pinpoint Trigger Example to find idle portion and start of each burst Reads/Writes separation by Transition Time (Writes) Example of AB Sequence Example of DDR-200 Reads/Writes separation by Transition Time (Writes) Reads/Writes separation by Transition Time (Reads) Example of Reads and Writes waveforms Reads/Writes separation by Runt Trigger (Writes) Reads/Writes separation by Runt Trigger (Reads) Example of Reads and Writes waveforms Reads/Writes separation by preamble width (Writes) * Find this idle portion and start of each burst of DQS by Glitch Trigger of A-Event. Set Glitch Width “Greater Than”. Set polarity positive when idle voltage is Vref (middle). Set polarity negative when idle voltage is 0V(low). Separate Writes from Reads by difference of transition time or amplitude using Transition Time Trigger or Runt Trigger of B-Event. Set polarity of glitch negative when idle portion is low level. (This is an example of DDR1) DDR-333 DDR-333 Find this idle portion and start of each burst of DQS by Glitch Trigger of A-Event. Set Glitch Width “Greater Than”. Separate Writes from Reads by difference of amplitude using Runt Trigger of B-Event. Enclose peak Set Width about 70% of peak pulse width Enclose peak Set Width about 70% of peak pulse width Find idle portion and start of each burst of DQS by Glitch Trigger of A-Event. Set Glitch Width “Greater Than”. Then, check difference of preamble width. Set A-Event trigger type Width to separate Writes from Reads by preamble width * * * *