钢框架-钢板剪力墙结构体系的试验研究与理论分析-结构工程专业论文.docxVIP

西安建筑 西安建筑科技大学硕 上学位论文 西安 西安建筑科技人学硕上学位论文 Experimeotal Aoalysis aod Theoretical Studies 00 Steel Frame-Steel Plate Shear Wall Structures Speciality: Structural Engineering A uth or: Li Yan Tnstructor: Prof: Hao Jipi ng ABSTRACT Steel plate shear wall has becomes a new type of lateral force resisting structure since 1970s. At presen t， Research on the steel plate shear wall becomes a hot topic at home and abroad.Even there is design method for thin plate shear wall in the American Institute of Steel Construction (AISC) Seism ic Provisions and CSA S16 Standard .However domestic research on steel plate shear wall is not enough . Most of them concentrate on the types of infill panels and there is little about types of beam and column connections.Therefore ，study on semi rigid connection steel frame-unstiffened thin steel plate sheer wall is importan t. ln order to investigate th e bearing capacity，hysteretic performance，ductility， stiffness and energy dissipation of the steel frame-steel plate shear wall s盯uctures with unstiffened welded-bolt ed connections，one 113 steel plate shear wall specimen with unstiffened welded-bolted connections was tested under cyclic load. Hysteretic curve， carrying capacity，ductility factor.警 viscous damping coefficient and cumulative energy dissipation curve are derived. The results show that the specimen was damaged ahead of time because of insufficien t stiffness of the out-of-plane constraintS.Besides there was no signiticant deformation ofthe connection Three kinds of finite element models are established to do some additional analysis to the test.The shear ratio of the steel plate and normal stress of the beam end cross-section are derived from the analysis of shell elements modeLThe shear ratio of the steel plate go th rough tive stages during the loading process. The normal stress of the beam end cross-section indicate that the connections of the beam and column transfer littile bending momentHysteretic curves a