CCNA实验10各种路由协议详情详情认识.docVIP

实用标准文案 精彩文档 徐来 mobil phone E-mail:breeze365@ ******************************************************************************* 该生用模拟器输入配置，且直接拷屏，没有做一引起处理，内容不可取，暂不修改 purpose：目标 1、static router(ip route [network] [subnetwork] [ip]) 静态路由 2、default router 默认路由 ip route .0 [ip] ip default-network [network] 3、dynamic router (rip) 动态路由 Network Topology网络拓扑图 We need: 要求 1. configure RIP between R1，R2 and R3 在R1，R2 and R3配置RIP路由协议 2. configure default network in R1,配置默认路由 ############################################################################### 问题：在模拟器中R1的（config）中不能配置default-network problem:i cant configure default-network in R1 with simulation ############################################################################### R1 Press Enter to Start Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R1 更改主机名 R1(config)#int s0 配置serial0 R1(config-if)#ip add 配置ip R1(config-if)#clock rate 56000 在DCE端配置时钟频率 R1(config-if)#no shut 开启端口 %LINK-3-UPDOWN: Interface Serial0, changed state to up R1(config-if)#exit %LINK-3-UPDOWN: Interface Serial0, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down R1(config)#int e0 配置Ethernet0 R1(config-if)#ip add 配置ip R1(config-if)#no shut 开启端口 %LINK-3-UPDOWN: Interface Ethernet0, changed state to up R1(config-if)#exit R1(config)#int s1 配置serial1 R1(config-if)#ip add 配置ip R1(config-if)#no shut 开启端口 %LINK-3-UPDOWN: Interface Serial1, changed state to up %LINK-3-UPDOWN: Interface Serial1, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to down R1(config-if)# %LINK-3-UPDOWN: Interface Serial0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to up %LINK-3-UPDOWN: Interface Serial1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to up R1(config-if)#eixt % Invalid input dete