IKO滚针轴承选型.docVIP

IKO滚针轴承选型 　　Identification Number 　　The identification number of Machined Type NeedleRoller Bearings consists of a model code, dimen-sions, any supplemental codes and a classificationsymbol. Examples are shown below. 　　Accuracy 　　Machined Type Needle Roller Bearings are manufac-tured based on JIS (See page 34.). The tolerancesfor the smallest single roller set bore diameter of bear-ings without inner ring are based on Table 14 on page36. For BR and BRI series, the accuracy is based onTable 2 and the tolerances for the smallest singleroller set bore diameter are based on Table 3. 　　Table 2 Accuracy of inner and outer rings of inch series BR and BRI 　　Remark for d mp , B s , C 　　s and ia , and for D mp and ea 　　Types 　　Machined Type Needle Roller Bearings are availablein various types shown in Table 1. 　　Caged Needle Roller Bearings 　　This type of bearing combines a collared outer ringwith the s unique lightweight rigid cage andneedle rollers. During operation, needle rollers areguided precisely by the cage, and an ideal load distri-bution is obtained. 　　The metric series consists of the NA48 and NA49series of ISO Standard, NA69 and TAFI series whichare based on the international dimension series, andthe heavy duty TRI series which is widely used inJapan. The TAFI series has a sectional height as lowas that of the shell type and is used for light loads.The inch series or BRI series is based on the specifi-cations of ANSI Standard of USA. 　　Caged Needle Roller Bearings without Inner Ring As shown in the section 　　so that the rotational accuracy is improved. Also, theshaft rigidity can be improved as the shaft diametercan be increased by an amount corresponding to theinner ring thickness. 　　Caged Needle Roller Bearings with Inner Ring 　　This type of bearing is used when the shaft cannot beheat-treated and finished by grinding. The outer andinner rings are separable and a small relief clearanceis provided on both sides of the inner ring raceway tofacilitate beari