髋臼中心定位器在人尸体髋臼的解剖学测量分析.pdfVIP

Anatomy analysis of using acetabulum center locator measure acetabulum of cadaver Abstract Objective: Disscuss a method about measure the distance between the midpoint of acetabular notch line connecting and the centre point of acetabular by acetabular center locator ACL. It can provide the anatomy basis for the man-made total hip arthroplasty (THA) to make sure the acetabular prosthesis is on the right place. Method steps:1.Select specimens of pelvis (40 hips) from 20 normal adults, peel the soft tissue of pelvis, then get the labrum acetabular, acetabular notch and Harris fossa.2.According to the intersection point of vertical diameter and horizontal diameter of acetabular bone to acquire the center point of acetabulum. And take notes about the distance between vertical diameter and horizontal diameter. Then use the acetabular center locator ACL to measure the distance between the midpoint of line connected with acetabular notehes to the acetabular center MAC.3.Analyse all the data with statistic analysis software help. Demonstrate the relationship between them. Outcome: Draw a scatter diagram according to the data of MAC with each of vertical line, horizontal line and the sum of vertical line and horizontal line. Directions: There was positive correlation between MAC and vertical diameter, horizontal diameter and the sum of vertical diameter and horizontal diameter. Use the SPSS19.0software to calculate pearson coefficient while R=0.89,0.81,0.91.According to the pearson linear analysis, compare with MAC and vertical diameter; MAC and horizontal diameter, we can see the variables coefficient between MAC and the sum of vertical diameter and horizontal di