oA桥梁检测.pptVIP

Data Collection and ProcessingMethodology Model 5100 天线 Concrete Condition Assessment of Bridge Decks using the Model 5100 Antenna * 工作照片 波形调整 Figure 3: Example of clipped waveform (gain set much too high). Clipping must be prevented for accurate rebar depth and amplitude measurements. Prior to collecting the data the user must manually decrease the gain. Figure 2: Badly positioned waveform. The direct coupling is not located in the window. Using the signal positioned as shown in this figure would cause the program to give erroneous results. Prior to collecting data the user must manually adjust the signal position until the direct coupling is located entirely in the window (see Figure 1). Figure 1: Typical waveform shape with antenna positioned over rebar. The signal is set up so that the direct coupling and the peak amplitudes are well within the boundaries of the sampling window. 波形图 混凝土钢筋检测剖面 桥梁检测处理对话框 钢筋位置确定方法 混凝土钢筋检测解释 Figure 6: Example of processed data shown in Interactive Interpretation window. The top half showing the picks on top of the data is the data pane. The bottom half showing the pick depths is the depth pane. 混凝土钢筋检测成果 * * * The reflection from a rebar appears as an arch or hyperbola. The correct location for the rebar reflection is near the center of the white portion of the arch. 钢筋反射为双曲线。反射的正确位置为白色部分的中心区域。 /***************************************************************************************** A 2-foot (0.6 m) spacing or less between adjacent profile lines (Y-spacing) is recommended. Mark the profile lines over which data will be collected. X方向10厘米；Y方向60厘米。 *****************************************************************************************/ If the SIR system beeps more than 2 or 3 times during data collection along a single profile line, reject this file and collect the profile again.. /***************************************************************************************** ? Collect and store a single data file per profile line