基于Hashin模型的甘蔗剪切仿真-湖南农业大学学报自然科学版.PDFVIP

() 2018, 44(1):101–105. DOI:10.13331/ki.jhau.2018.01.019 Journal of Hunan Agricultural University (Natural Sciences) 基于 Hashin 模型的甘蔗剪切仿真 ( 541004)   摘 要VUMAT Hashin 270 N 30°5° 2 mm 关 键 词 + 中图分类号：S225.5 3 文献标志码：A 文章编号：1007− 1032(2018)01−0101−05 Simulation of sugarcane cutting based on Hashin failure model XIONG Wei (School of Mechanical Engineering, Guilin University of Aerospace Technology, GuilinGuangxi 541004 China)   Abstract: Finite element method is used to simulate the cutting process of sugarcane to study the influence of blade geometry on the morphology of sugarcane. Through programming VUMAT subroutine, the Hashin unidirectional fiber composite failure criterion is applied to the simulate the cane shearing process to achieve the fracture morphology of sugarcane shearing process, the maximum shear force of the shearing process, the influences of blade wedge angles, the relief angles and the clearance on the shear section. Results show that the fracture morphology obtained by simulation are consistent with existed experiment and simulation results. The maximum shear force is 270 N. When the wedge angle is decreased from 30o o to 5 , the upper and lower shear section of sugar cane tends to be flat. Positive relief angle leads to smoother lower shear section. The existence of 2 mm blade gap causes tearing in the part of lower fracture near the stationary blade. Keywords: sugarcane; cutting; failure criteria; simulation [1] [5] ANSYS/LS–DYNA