辽宁省某城镇污水处理工艺设计.docVIP

内蒙古科技大学 本科生毕业设计说明书 题 目：辽宁省某城镇污水处理工艺设计 学生姓名：王凯明 学 号：1276808319 专 业：环境工程 班 级：环境12—3班 指导教师：陈莉荣 教授 辽宁省某城镇污水处理工艺设计 摘 要 本次毕业设计是以相关的资料为依据,设计一座城镇污水处理厂.其日处理量为10万立方米。由于城市污水的主要成分为有机物,所以本次设计采用了氧化沟工艺. 主要任务是工艺流程选择及构筑物设计和计算。 该污水处理厂的污水处理流程为：污水经过中格栅，由泵房提升后流过细格栅，进入沉砂池、厌氧池，再进入氧化沟，二沉池，最后消毒排出。 在完成污水和污泥处理构筑物的设计计算后,根据平面布置的原则,综合考虑各方面因素进行了污水厂的平面布置。据污水的流量对连接各构筑物的管渠进行了选径、确定流速以及水力坡降,然后进行了水力损失计算。据水力损失计算对污水和污泥高程进行了计算和布置。 在最后阶段完成对平面图、高程图及各主要构筑物平剖面图的绘制。 关键词：污水处理；厌氧反应池；奥贝尔氧化沟；脱氮除磷；污泥浓缩 Design of wastewater treatment technology in a town in Liaoning province Abstract This graduation project is take the related material as the basis, designs a town sewage treatment plant. Its day process load in the near future will be 100,000 cubic meters. Because the city sewage principal constituent is an organic matter, therefore this design has used the oxidation ditch craft. The main task is the selections of process flow and the designs and calculation constructions used in process flow. The process of the sewage treatment plant: sewage come across the middle grid, sewage was lifted up by fine screens , and then it enters the laminar flow sand pool, oxidation ditch, secondary sedimentation tank, finally The water falls out through a pipe a long way out to river. After finishing calculation of design, according to principle of laying, consider the factors synthetically to confirm the place of the sewage factory. According to flow volume of sewage we can select the foot-path , confirm the velocity of flow and water conservancy slope , then calculate water conservancy losses. In the end, Floor plan, profile in elevation and the other mainly structures drawing must finished. Key words：Water treatment; Anaerobic reactor; Orbal oxidation ditch; Phosphorus Sewage and Nitrogen; Sludge concentratio 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc451692480 辽宁省某城镇污水处理工艺设计 PAGEREF _Toc451692480 \h 0 HYPERLINK \l _Toc451692481 摘 要 PAGEREF _Toc451692481 \h 0 HYPERLINK \l _Toc451692482 Design of wastewater tre