DCDC多模块组合变换系统的稳定性分析及实验验证.PDFVIP

DC/DC 多模块组合变换系统的稳定性分析及实验验证 DC/DC Conversion Systems Consisting of Multiple Converter Modules: Stability, Control and Experimental Verifications 南京航空航天大学 陈武，阮新波 Email: chenwu@nuaa.edu.cn, ruanxb@nuaa.edu.cn 摘要﹕本文揭示了 DC/DC 多模块组合变换系统中各模块输入均压/均流与输出均压/均流的内在关系，分析了输 入均压/均流(输出均压/均流)调节器与输出电压调节器之间的关系。在此基础上，提出一种适合 DC/DC 多模块组合变 换系统的控制策略，它实现了输入均压/均流(输出均压/均流)调节器与输出电压调节器的解耦控制。该控制策略可以 实现多模块组合变换系统的模块化，且不需要额外的控制环节。论文最后以 3 台全桥变换器的串并联组合系统验证 了该控制策略的有效性。 Abstract: This paper investigates the inherent relations between input/output variables (voltage or/and current) sharing of dc/dc conversion systems, which consist of multiple converter modules connected in series/parallel at both the output and input sides. In the meanwhile, relationships between input and output variables sharing regulators and output voltage regulator as well as the stability of control strategy are also analyzed. Based on the analysis, a general control strategy for series-parallel system is proposed, which decouples the output voltage control loop and input/output variables sharing control loop. Furthermore, three modularization architectures are proposed for ISOP, IPOS and ISOS, respectively. They achieve pure modulization design and no external controller is needed to regulate input/output variables sharing. Several prototypes are also built in lab to validate the general control strategy and the proposed modularization architectures. 关键词﹕平衡；输入/输出；均压/均流；稳定性；控制策略；模块化 Keywords: Equilibrium; input/output voltage/current sharing; stability; control strategy; modularization. 保各模块之间的平衡，即模块输入或者输出串 1 引言 联时，必须确保输入均压 (Input voltages 由多个标准化DC/DC变换器模块分别在 sharing, IVS) 或者输出均压(Output voltag