基于ads的uhf读写器硬件电路设计与仿真调试-电机与电器专业论文.docxVIP

AbstractRFID Abstract RFID is a new technology of non．contact automatic identification which is widely used in various fields．At Present，the domestic researching based on UHF reader is still in its Primary stage．Aiming at the weakness of UHF RFID reader by the discrete components，such as too many components，high cost,high power consumption,and SO on；this paper use AS3990 as RF integrated chip，study the base-band circuit and the RF part and completed the circuit design and debugging． Firstly,the development,Principle and system structure of RFID were introduced．The ISO／IEC 1 8000·6 type C standard Was analyzed and the communication between reader and the electronic tag was detailed analyzed，and the theory of RF communication system was researched．On the basis of reader,the paper detailed analyzed the RF circuit structure and working principle． Secondly,this Paper design the reader codee circuit based on FPGA in the base-band circuit；FPGA Can precisely define the reader Tad values，SO that the readers accuracy Was significantly improved．Meanwhile,this paper selected the CC430F61 37嬲the master chip and reduced losses by setting the operating mode． 砀e efficiency of reader Can be improved using the way to implement a single power supply for FPGA、CC430F6137 and the memory．TIlis paper listed the various parts of the base-band circuit schematic and the result which Was simulated by ADS showed that the base-band circuit had good performance． Thirdly,this paper designed the RF circuit based on AS3990；Using RF2173 as control chip，RF signal debugging circuit Can inhibit noise；Using SPA-2 1 1 8 as control chip，RF power amplifier circuit Can achieve power amplification．Thc RF circuit was designed to reduce the cost and power consumption according to the features of the UHF RFID reader．At she same time，the receiver sensitivity Was improved also． Finally,according to the system design requirements，a UHF RFID reader prototype Was developed，power amplifier circuit was experimented and