ARM编程之ADC模数转换.docx

#include stm32f10x.h #include stm32_eval.h #include stdio.h #define DR_ADDRESS ((uint32_t)0x4001244C) //ADC1 DR寄存器基地址 USART_InitTypeDef USART_InitStructure; //串口初始化结构体声明 ADC_InitTypeDef ADC_InitStructure; //ADC初始化结构体声明 DMA_InitTypeDef DMA_InitStructure; //DMA初始化结构体声明 __IO uint16_t ADCConvertedValue;// ADC为12位模数转换器，只有ADCConvertedValue的低12位有效 #ifdef __GNUC__ /* With GCC/RAISONANCE, small printf (option LD Linker-Libraries-Small printf set to Yes) calls __io_putchar() */ #define PUTCHAR_PROTOTYPE int __io_putchar(int ch) #else #define PUTCHAR_PROTOTYPE int fputc(int ch, FILE *f) #endif /* __GNUC__ */ //延时函数 static void Delay_ARMJISHU(__IO uint32_t nCount) { for (; nCount != 0; nCount--); } int main(void) { u16 ADCConvertedValueLocal, Precent = 0, Voltage = 0;//变量定义 //串口配置 USART_InitStructure.USART_BaudRate = 115200;//波特率设定 USART_InitStructure.USART_WordLength = USART_WordLength_8b;//8位数据帧 USART_InitStructure.USART_StopBits = USART_StopBits_1;//一个停止位 USART_InitStructure.USART_Parity = USART_Parity_No;//无奇偶校验 USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;//无硬件流控 USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;//设置串口为接受和发送模式 STM_EVAL_COMInit(COM1, USART_InitStructure);//完成串口COM1的时钟配置、GPIO配置，根据上述参数初始化并使能 //从串口打印相关数据 printf(\n\r\n\r\n\r\n\r); printf(\n\rUSART Printf Example: retarget the C library printf function to the USART\n\r); printf(\r\n\n\n WWW.ARMJISHU.COM %s configured...., EVAL_COM1_STR); printf(\n\r ############ WWW.ARMJISHU.COM! ############ (__DATE__ - __TIME__ )); printf(\n\r 论坛后续还会有更多精彩的示例，欢迎访问论坛交流与学习.); printf(\n\r 本示例为AD转换示例，串口输出转换结果，模拟信号来自板上的电位器！ \n\r); printf(\n\r==============================================================================); printf(\n\r); RCC_AHBPeriphClockCmd(RCC_AHBPeriph_DMA1, ENABLE);//使能DMA时钟 //DMA配置 DMA_DeInit(DMA1_Channel1);//开启DMA1的第一通道 DMA_InitStructure.DMA_PeripheralBase