谈后浇带的设计说与施工.docVIP

谈后浇带的设计与施工 Abstract: the new release of code for design of concrete structures (GB 50010-2002, hereinafter referred to as the concrete specification), the reinforced concrete structure of the largest joint spacing requirements than the strict norms, norms used by the word may should be changed to . This requires in the structural design, the designer must be taken seriously due to long to structure the negative influence, when the distance increases or structural joints is no expansion joint, must take practical measures to prevent the cracks of the structure. Key words: post pouring belt; design; construction The new release of code for design of concrete structures (GB 50010-2002, hereinafter referred to as the concrete specification), the reinforced concrete structure of the largest joint spacing requirements than the strict norms, norms used by the word may should be changed to . This requires in the structural design, the designer must be taken seriously due to long to structure the negative influence, when the distance increases or structural joints is no expansion joint, must take practical measures to prevent the cracks of the structure. In increasing the spacing of the largest joint measures, take prevention measures in construction stage is an effective method for the general concrete shrinkage reducing the adverse effects of our common approach is to set the construction of the pouring belt. In addition, when the building there is a big difference, but the structure design according to the specific circumstances can not set up permanent deformation joints, such as high-level and multi-storey main building (or lower) between the podium, construction is often used after pouring to resolve the differences in the construction phase of the settlement. These two kinds of construction after pouring belt, the former can be called shrinkage after pouring belt, the latter can be called post settlement belt. In this paper, after the construction of the design and co