直接淬火低碳贝氏体钢的回火组织与力学性能-Engineering.PDF

36 / 20 3 T empering Microstructure and Mechanical Properties of Low Carbon Bainitic Steel Directly Quenched , , , ( , 00083) WANG L-i jun, WU Hu-i bin, YU Wei, CA I Qing-w u ( National Engineering Research Center for Advanced Rolling T echnology, U niversity of Science and T echnology Beijing, Beijing 00083, China) : SEM, TEM , Fe-Mn-Mo-Nb-Ti , 580 , 805MPa, 7 9M Pa, 25. 8% , - 20 06J,, , , , 620 , , ( Nb, Ti) ( C, N) , 0~ 20nm, : ; ; : T G 42. : A : 00 -438 (20 ) 03-0036-04 Abstract: Effects of different tempering temperature on the microstructure and mechanical properties of the directly-quenched steel w ere investigated by SEM , T EM and other experimental methods. The results indicate that the tested steel obtain the best comprehensive mechanical properties w ith tensile strength of 805MPa, yield strength of 7 9MPa, elongation of 25. 8% and impact energy of 06J at - 20 . T he recovery of lath bainite become even more clear w ith increasing tempering temperature. The smal-l angle grain boundaries in lath bainite gradually disappear through motion, merging and re- organization of dislocation, w hich cause lath w ider. It w as found that bainite lath boundaries blurred, the dislocation network located in bainite and the precipitation of ( Nb, T i ) ( C, N) composite phase w ith the average size of 0-20nm after tempering at 620 . Mechanical properties w ith tempering tem- perature show non-monotonic nature, w hich is ascribed to the comprehensive mechanism including the recovery softening process of dislocation substructure, and the strengthening mechanism due to the dissolution of carbon and