带构造柱窗间墙抗震试验的有限元分析-土木工程专业论文.pdf.docxVIP

太原理工大学硕士研究生学位论文行了弹塑性时程分析对比，得出有构造柱和砂浆强度高的砌体结构其抗震 太原理工大学硕士研究生学位论文 行了弹塑性时程分析对比，得出有构造柱和砂浆强度高的砌体结构其抗震 性能要优于无构造柱和砂浆强度低的砌体结构。 关键词：窗间墙，砌体结构，破坏形态，有限元，抗震性能 万方数据 太原理工大学硕士研究生学位论文FINITE 太原理工大学硕士研究生学位论文 FINITE ELE^4ENT ANAIjYSIS 0F M-AS0卜fRY WALL’S EⅫERIⅧNTALONSEISMICTESTFORMASONRYPIERS MTH STRUCTI佩AI，COLI心S AB STRACT This paper focuses on the wall between the windows with a structural column seismic finite element simulation analysis，focusing on the failure mode of the wall，deformation capacity,energy dissipation capacity,carrying capacity and other characteristics were analyzed． Firstly,show previous damage，building damage masonry structures more serious seismic performance to be improved．This article first development status masonry structure，Present Situation failure modes are outlined，we discussed how to improve the seismic performance of masonry and the development direction of masonry structure proposed content and purpose of this article．In this paper,this quasi-static test were introduced，including the bathroom with a window wall structure column specimen design and installation， and the load on the loading device of the present experiment also made a brief introduction．The conclusion that the results of this test，the wall shear failure， seismic performance to be improved． In this paper，finite element software ABAQUS a brief introduction， introduces the establishment of model selection and calculation principle software and finite element model unit and determine model parameters and comparative analysis of the model last．By using ABAQUS finite element III 万方数据 太原理工大学硕士研究生学位论文analysis 太原理工大学硕士研究生学位论文 analysis software the following conclusions： (1)The optimal loading height window wall between test finite element model is 2200mm． (2)Whether the comparison between the two windows through structural column wall model found structural column can significantly improve the seismic performance of the wall between the windows，but also Can improve the ductility of the wall． (3)T