《化学镀用光亮剂研究》-毕业论文设计（可用）.docVIP

PAGE PAGE 14 2012届本科毕业论文（设计） 论文题目：化学镀用光亮剂研究 学生姓名： 所在院系：机电学院 所学专业：机械设计制造及自动化 导师姓名： 完成时间：2012年5 月10日 摘 要 本试验是通过向镀液中加入所选用的光亮剂中间体，使用碳钢试片作为基材，以提高试片表面光亮度为目的的化学镀试验。由于光亮组分较多，所以分别进行了四因素三水平试验和三因素两水平正交试验，对各中间体浓度进行增减优化，从而找到最优配方。该配方为:DEP45mg/l, PME15mg/l, OP-10 10mg/l,VS25mg/l, BSI750 mg/l, PS200mg/l, PPS-OH400mg/l。得出最优配方后，为确保试验结果的准确性。又进行了检验试验,结果表明，该优化配方是好的。 关键词：光亮剂，正交试验，表面光亮度，化学镀。 Chemical nickel plating brightener optimization experiment Abstract The test principle is to add sulfuric acid nickel plating selected brightener intermediates, use carbon steel test pieces as base material, and try to improve on the surface of brightness for the purpose, chemical plating test. Will the mother material processing put in 85 ℃ after plating baths to heat preservation 40 minutes, after drying treatment using brightness measuring instrument measuring its brightness values. The orthogonal design software data analysis to determine the development plan, the four factors are three level test three factors and two levels orthogonal test, the intermediate increase or decrease concentration optimization, and find the best formula. The optimal formula that see table 1. DEP45mg/l, PME15mg/l, OP-10 10mg/l,VS25mg/l, BSI750 mg/l, PS200mg/l, PPS-OH400mg/l. The optimal formula obtained to ensure the accuracy of the test results. The inspection and test, namely the selective repeat some test. Keywords: brightener, orthogonal test, the surface brightness, chemical plating.  目录 TOC \o 1-6 \h \z \u HYPERLINK \l _Toc325036992 1 绪论 PAGEREF _Toc325036992 \h 1 HYPERLINK \l _Toc325036993 2 试验材料和方法 PAGEREF _Toc325036993 \h 2 HYPERLINK \l _Toc325036994 2.1中间体的选取 PAGEREF _Toc325036994 \h 2 HYPERLINK \l _Toc325036995 2.2 试验方案的确定 PAGEREF _Toc325036995 \h 3 HYPERLINK \l _Toc325036996 2.3实验仪器 PAGEREF _Toc325036996 \h 4 HYPERLINK \l _Toc325036997 2.4基体材料与化学镀工艺流程 PAGEREF _Toc325036997 \h 4 HYPERLINK \l _Toc325036998 2.5 试验过程 PAGEREF _Toc325036998 \h 6 HYPERLINK \