气门摇杆轴支座加工工艺与夹具设计.docVIP

┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 装 ┊ ┊ ┊ ┊ ┊ 订 ┊ ┊ ┊ ┊ ┊ 线 ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ ┊ 毕业设计（论文）报告纸 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT 6 毕业设计说明书 课 题 名 称 气门摇臂轴支座加工工艺及钻床夹具 设计 分 院/专 业 班 级 学 号 学 生 姓 名 指导教师： 二〇一六年五月 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT I 摘要 本次课题是是气门摇臂轴支座的的孔的钻床夹具设计。流程大致如下：零件加工工序，零件设计方案，确定计算过程和零件夹具设计。 本零件表面加工方法的选定、零件的工艺路径选定、零件的工艺装备的选定、零件的加工步骤的划分、零件的精工设备的选定、零件毛坯的尺寸、零件加工余量、零件的公差的选定等对于制作工艺规程都是需要解决的问题。而这个零件的夹具设计需要考虑的是零件的定位误差的计算与分析、零件定位方案的选定、零件定位元件的选择、钻床夹具夹紧力的计算、夹具体毛坯的结构及夹具元件配合的选定。 经过这次设计对零件的工艺规程、专用夹具、零件工艺路线的制定、零件的工艺方案的选择有了更深刻的认识。还有零件结构的合理设计、加工工艺性的设计，保证它的加工质量，对于提高零件的生产效率起着十分重要的意义。通过对这个零件的加工过程的设计，可以看出每个加工过程很好的配合是设计出一个好的产品的关键。 关键词：机械零件；加工工艺；钻床夹具；定位；夹紧 Abstract This topic is the valve rocker arm shaft bearing hole drilling fixture design Process is as follows: roughly parts processing process, parts design scheme, calculation process and parts fixture design is determined. This parts selection of surface machining method, parts of process path selected, parts of the selection of process equipment, parts of the division of process steps, selection of parts of seiko equipment, parts of blank size, parts machining allowance, parts tolerance of the selected for production process procedures are need to solve the problem. And the parts of fixture design is to consider parts of calculation and analysis of fixing error, selection of scheme of parts, parts positioning element selection, drilling fixture clamping force calculation, clip the specific structure of blank and fixture element with selected. After the design of parts of process planning, process routes of the special fixture, parts development, parts of the choice of process scheme had a more profound understanding Parts and the design of the structure of reasonable design, processing technology, guarantee the quality of it, to improve the production efficiency of parts plays a very important significance. Through the design of the machining process of t