选择性射孔在综合开发中的应用.ppt

Application of selective perforation in Comprehensive development before enhance oil recovery after the polymer flooding. Nev. 25,2011 Application of selective perforation in Comprehensive development before enhance oil recovery after the polymer flooding. For Simplicity,the title is called SPCD 1.why using SPCD 1.1 the characteristic of residual oil after polymer flooding 44.4% remaining oil is distributed in slight and unflushed section. Ratio(%) highly flushed moderately flushed sight flushed unflushed 1.why using SPCD 1.1 the characteristic of residual oil after polymer flooding Types of remaining oil In the Thick layer 岩心水洗剖面 测井曲线 PI4 In the thin layer 岩心水洗剖面 测井曲线 PI1 targets of SPCD Alternative distribution 1.why using SPCD 1.2 after Polymer Flooding, no feasible techniques can get good result in enhancing thin layer oil recovery polymer flooding (PF) high concentration polymer flooding (HPF) (high molecular weight/high concentration) SP flooding (surfactant + polymer) ASP flooding (alkali + surfactant + polymer) Foam flooding (FF)(co2+surfactant/natrual gas + surfactant) Techniques used: High Permeability Zone HPF PF After different flooding Way, the HPZ’s So is very Low. SP ASP FF Laboratory displacement experiment so Laboratory displacement experiment moderate Permeability Zone SP ASP FF HPF PF so After different flooding Way, the MPZ’s So is also Low. SP But in LPZ, There Still have a relatively high So ASP FF HPF PF Laboratory displacement experiment so low Permeability Zone In the actual development of this kind of oilfields, thin layer is more hard to be flooded Due to interlayer Inconsistency，low Permeability Zone Still have a high So. All Techniques used can not get good result in enhancing thin layer oil recovery The above is the main cause to choice SPCD 3. Applied case basic parameter area，km2 1.9 layer PI1、PI3-7 Well number 50 Well spacing（m） 175 Sand(ｍ) 9.5 pay(ｍ) 3.6 3.1 target area : completed polymer floodi