罐式集装箱跌落仿真与试验.pdfVIP

第38 卷 第 11 期 包 装 工 程 2017 年6 月 PACKAGING ENGINEERING ·79 · 罐式集装箱跌落仿真与试验 王威涛 1 ，杨献朝 2 ，陈荣昌 2 ，刘晨 2 ，石宁 1 ，王奎升 1 （1.北京化工大学，北京 100029; 2.交通运输部水运科学研究院，北京 100088 ） 摘要： 目的 研究裙座与鞍座 2 种连接结构的罐式集装箱在长侧面跌落情况下的应力状态以及结构薄弱 点。方法 基于有限元软件对 2 种结构的罐式集装箱进行仿真模拟分析，制作 2 种结构的罐式集装箱试 件，并进行 2.8 m 高度的跌落试验，对比分析仿真模拟结果与试验分析结果。结果 端梁发生了屈服变 形，罐体与框架连接处结构承受了较大应力，并发生损坏。结论 试验与仿真模拟结果基本一致，为罐 式集装箱改进设计提供了理论依据。 关键词：罐式集装箱；有限元分析；跌落仿真；应力测试 中图分类号：TB485.3; O347.3 文献标识码：A 文章编号： 1001-3563(2017)11-0079-05 Drop Simulation and Experiment on Tank Containers 1 2 2 2 1 1 WANG Wei-tao , YANG Xian-zhao , CHEN Rong-chang , LIU Chen , SHI Ning , WANG Kui-sheng (1.Beijing University of Chemical Technology, Beijing 100029, China; 2.China Waterborne Transport Research Institute, Beijing 100088, China) ABSTRACT: The work aims to study the stress status and structural weakness of the skirt type and saddle type tank con- tainers in the case of long-side dropping. Based on the finite element software, the two types of tank containers were si- mulated and analyzed. In addition, the two structural forms of tank container specimens were produced for drop test at 2.8 m height. The results of simulation and test analysis were comparatively analyzed. The yield deformation of the end beam occurred, and the junction structure of tank and frame was damaged because of the large stress borne. The experimental results are in accordance with the simulation results, which provides theoretical basis for improving the design of tank containers. KEY WORDS: tank container; finite element analysis; drop simulation; stres