uwb系统零中频超宽带接收机设计电路与系统专业论文.docxVIP

AbstractAbstract Abstract Abstract UWB is emerging wireless technology capable of high data rate transmission over wide spectrum of fjrequency band with very low power．The US Federal Communications Commission(FEE)approved of UWB for commerciaJ use in February 2002．The I『、7忸technology has a number of excellent features．and iS a very competitive short—range wireless transmission technology． As the core block of UWB system．the RF receiver iS has been paid much more attentions．This paper is emphasis on the design and realization of low power lower noise and hi曲linearity Zero-IF receiver．Beginning with the UWB wireless communication protocol and adopting the“Top—Down’design methodology，this paper discussed the noise and linearity of the receiver detailedly and then divided the system performances to each sub．block parameters of the RF receiver．In order to get rid of DC—offset problem．DC．100p feedback of VGA method is used which can move large On—chip AC—coupled capacitors to Off-chip，SO the method much chip area．’lhis design is fabricated in SMIC 0．1 8um RF CMOS process．and measured by Chip—on—board Method on PCB．The Measurement results shows the receiver can achieve a maximum gain of 47．6dB across 3-5GHZ．The minimum detected signal iS 一70dBm．and the input match iS better than一8dB．The power consumption of the whole receiver iS 50mW．and the Zero—IF receiver has been successfully used in I舯 system which can transmit high—definition video smoothly． As the main blocks of Zero—IF receiver system，this paper gives the design process of LNA，Mixer and RF switches detailedly． From the single MOSFET switch model．the insertion lOSS iS deduced quantitatively，and the relationship between insertion loss and substrate resistance is given．Measurement results showed the insertion loss of 1．9dB．the reverse isolation of27dB and the chip area of 100u*150u． As for the U、N售U、IA，the input match，noise figure and gain flatness are analysed．Across 3～5GHz．the measured power gain is 1 3．2dB with a