【5A版】网络基础知识篇.pptVIP

Slide 1 of 1 Purpose: Emphasize: Another way to learn about a remote device is to connect to it. Telnet, a virtual terminal protocol that is part of the TCP/IP protocol suite, allows connections to remote hosts. By default, a router can have up to five simultaneous incoming Telnet sessions. With Cisco’s implementation of TCP/IP, you need not enter the connect or telnet command to establish a Telnet connection. If you prefer, you can just enter the learned host name, the router will resolve the hostname using DNS or a local host table. To end a Telnet session, use the exit or logout EXEC command. These are alternate commands for the operations listed on the graphic: Initiate a session: Denver connect paris Denver paris Denver 52 Resume a session (enter session number or name): Denver 1 Paris End a session: Paris exit Note: The Cat 1900 can accept incoming telnet connections but can not initiate an outgoing telnet session. Slide 1 of 1 Purpose: Emphasize: Note: This output was taken from a 2522. Line 11 = VTY 0. You can send messages to one or all terminal lines. A common reason for doing this is to inform users of an impending shutdown. To send a message to other terminals, issue the following command: send {line-number | *} Syntax Description line-number Specifies the line number to which the message will be sent. * Indicates that the message will be sent to all lines. The system prompts for the message, which can be up to 500 characters long. End the message by entering Ctrl-Z. Enter Ctrl-C to abort the command. Slide 1 of 1 Purpose: Emphasize: Use the show version command to display the value of the Config register setting. When you change the config register, we will see from the show version output: Configuration register is 0x2102 (will be 0x2142 at next reload). The new config register value will be used at the next reload. Slide 2 of 4 Purpose: Emphasize: Layer 2—Adds the table that identifies the boot field Config