双旋转毂式矫直机的优化设计莫翰林1孙东明1王立铮1钟晨1翟富兵2.DOCVIP

双旋转毂式矫直机的优化设计 莫翰林1孙东明1王立铮1钟晨1翟富兵2王天兵2 （1昆明理工大学 云南 昆明 650500 2新疆新鑫矿业股份有限公司阜康冶炼厂 新疆 昌吉 831500） 摘要：目前电解法作为纯镍生产的主流方法被广泛采用，其主要特点为通过导电棒引导电流，最终将电流导向种板。因此在实际生产中由于受到承重、撞击等各种因素的影响，导电棒会产生形变。因为整个电解过程的效率和自动化程度的提高需要使用满足要求直线度的导电棒，所以一个电解周期后必须矫直产生形变的导电棒。本文以国内某镍冶炼厂中规格为Φ36 ×3 ×1350 的电镍导电棒为研究对象，对转毂式斜辊矫直机进行研究，利用优化后的矫直机矫直编为两组的20根电镍导电棒，对矫直后的导电棒进行测量，并分析比较其平直度，从而验证该种矫直机能否完成电镍导电棒的矫直。 关键词：转毂式矫直；电镍导电棒；参数分析 中图分类号：TF305 文献标志码：A 文章编号： The Optimization Design of Leveller with Double Rotary Hub MO Hanlin1,SUN Dongming1,WANG Lizheng1,ZHONG Chen1,ZHAI Fubing2,WANG Tianbing2 (1.Kunming University of Science and Technology, Kunming 650500, China 2. Fukang Smelter of Xinjiang Xinxin Mining Industry Co., Ltd., Changji 831500, China) Abstract: For the moment, electrolytic method is widely used as the mainstream method of pure nickel production. The main characteristic is to guide the current through the conductive rod, and finally the current is guided to the plate. Therefore, in actual production, due to the influence of bearing, impact and other factors, the conductive rod will undergo deformation. Because the efficiency of the whole electrolysis process and the improvement of the degree of automation need to use the conductive rod that meet the required straightness, these conductive rods must be straightened after an electrolytic cycle. In this text, we study rotary bevel type roller straightening machine by choose conductivity rod with a size of 36×3×1350 in a domestic nickel smelter for the study. By using the optimized straightener to straighten two groups of 20 electric nickel conductive rods, measuring these conductive rods and analyzing their flatness, and verifying whether the straightener can complete the straightening of the electric nickel conductive rod. Key words: straightening of rotating the hub; the conductive rod; analysis of straightening parameters 0 引 言 镍是具有磁性的银白色展性金属。目前纯镍的主要制法是通过电解法制作，在整个生产流程中，导电棒将电流从电解槽导向阳极板和阴极板。因此，导电棒的主要功能则是引导电流。若导电棒产生形变，则会极大地影响整个生产过程