导致卷扬下降无动作Faultanalysis.PPT

压力补偿器故障主要是钢球封不住油，导致反馈油路泄露。 The main reason for failure of pressure compensator is that the steel ball cannot retain the oil, resulting in leakage of feedback oil line. 钢球 Steel ball 弹簧 Spring 补偿阀阀体 Compensation valve body 复位弹簧 Reset spring 组合垫圈 Combination washer 6 上部操纵阀部分 Superstructure control valve * * 顺带介绍一下3大部套Introduce the three big assemblies by the way * * 伸缩 Telescope 接控制阀B2口 To control valve port B2 变幅 Derricking 接控制阀B1口 To control valve port B1 接控制阀B3口 To control valve port B3 副卷 Auxiliary winch 接控制阀B7口 To control valve port B7 主卷 Main winch 接控制阀B5口 To control valve port B5 接右手柄R1口 To right lever port R1 接控制阀B6口 To control valve port B6 接控制阀B9口 To control valve port B9 解决方法： Troubleshooting 清洗5MPa溢流阀。 Clean the relief valve of 5MPa. 2 回转、支腿部分 Slewing mechanism and outrigger 伸缩部分 3 Telescope 3-1 伸缩吊臂时抖动 3-1 Shake during boom telescoping 伸缩时次级溢流阀压力调节过高。 The pressure of secondary relief valve is too high during telescoping. 3-2 伸一正常，伸二无动作 3-2 Telescopic cylinder I works normally but telescopic cylinder II doesn’t . 伸缩切换用电液换向阀不工作（电磁铁不工作或阀芯不动作） The electro-hydraulic reversing valve for telescope shifting does not work (the electromagnet or valve element does not work) 伸缩 Telescope 接控制阀B2口 To control valve port B2 接控制阀B5口 To control valve port B5 3 伸缩部分 Telescope 3-3 伸一下沉 3-3 Telescopic cylinder I retracts 伸一平衡阀内泄或油缸内泄。 Telescopic cylinder I balance valve or cylinder leaks inside.  3-4 伸二下沉 3-4 Telescopic cylinder II retracts 伸二平衡阀内泄或油缸内泄。 Telescopic cylinder II balance valve or cylinder leaks inside. 3 伸缩部分 Telescope 卷扬部分 4 Winch 4-1小开口抖动 4-1 Small opening shakes 卷扬小开口抖动可区分这种抖动是否在马达的最低稳定转速范围内（≤50r/min），可查看卷筒的转速是否在1-1.5r/min之内，如果是，则因马达的使用范围决定了这种情况。 Winch small opening shakes: check if this shaking is within the minimum stable speed range of motor (≤50r/min) and if the reel speed is within 1-1.5r/min; if yes, this shaking is unavoidable because of the service range of motor. HA控制 HA control 4 卷扬部分 Winch 可