基于DSP的视频监控系统终端的设计与实现-计算机系统结构专业论文.docxVIP

II II Abstract With the development of computer, network, communications and multimedia technology, the embedded system has become a new focus and orientation in IT field following the step of computer and network technology. Still, with the development of video codec, the IP Camera developed a lot and was widely used in surveillance, video conference and many other areas. An IP Camera system realizing the video decoder in the platform of DSP (TMS320DM642) is designed and implemented. This system is very small and it runs fast and stably, it could let people communicate fluently in high definition image. This system has great reference value for wide application use. The hardware is the base of the system. With the introduction of hardware architecture of the system, the details of how to design the system is introduced. Also, how to setup and configure the CCS IDE provided by TI is introduced before the introduction of software design. Driver development has a key role and is very important in the system development. Based on introducing the hardware and driver architecture, taking VPORT Minidriver, WatchDog, UART driver and Bootloader as an example, the driver development process on DSP is described in details. Finally, the hardware and driver module is tested through testing program. It is proved well and can widely used in real project. Key words: Bootloader, WatchDog, Minidriver PAGE PAGE IV 目 录 摘 要 I Abstract II HYPERLINK \l _bookmark0 1 绪论 HYPERLINK \l _bookmark1 1.1 课题的背景和意义 (1) HYPERLINK \l _bookmark2 1.2 数字信号处理器以及 TMS320DM642 简介 (2) HYPERLINK \l _bookmark3 1.3 本文主要研究工作与结构安排 (4) HYPERLINK \l _bookmark4 2 系统硬件设计 HYPERLINK \l _bookmark5 2.1 嵌入式系统的特点 (6) HYPERLINK \l _bookmark6 2.2 嵌入式处理器分析与选择 (7) HYPERLINK \l _bookmark7 2.3 流媒体终端硬件技术分析 (8) HYPERLINK \l _bookmark8 2.4 视频监控系统的总体硬件结构 (10) HYPERLINK \l _bookmark9 2.5 视频监控系统的模块设计 (11) HYPERLINK \l _bookmark10 2.6 高速 PCB 设计 (17) HYPERLINK \l _bookmark11 2.7 本章小结 (19) HYPERLINK \l _bookmark12