导爆管成卷捆扎机的设计-包装工程.PDF

包 装 工 程 第 37 卷 第 17 期 ·172 · PACKAGING ENGINEERING 2016 年 9 月 导爆管成卷捆扎机的设计 杨秀英，程玉来 （沈阳工学院，抚顺 113122 ） 摘要： 目的 设计一种导爆管自动捆扎机，通过该设备实现导爆管的自动捆扎。方法 在分析捆扎工 艺路线的基础上，对实现其基本功能进行分解，并将基本功能进行组合，确定整机结构方案，采用 单根成卷，10 根捆扎工艺，以旋转构件实现缠绕成卷，直动气动原件实现单根的推送及 10 根的捆 扎、以胶带作为捆扎材料实现对成卷后的 2 处捆扎。结果 经 2 轮样机的试制、改进及实际生产考 核，完成了导爆管成卷捆扎机的设计、制造。该机每班捆扎的生产率为 700 捆/8 h ，达到预期设计 目的和要求。结论 设计的导爆管自动捆扎设备可以提高生产率，减轻劳动强度，降低生产成本。 关键词：导爆管；自动捆扎；设计 中图分类号：TJ45+7 文献标识码：A 文章编号：1001-3563(2016)17-0172-05 Design of Binding Machine for Plastic Nonel YANG Xiu-ying, CHENG Yu-lai (Shenyang Institute of Technology, Fushun 113122, China) ABSTRACT: The work aims to design an automatic strapping equipment to finish automatic strapping of the nonel. Based on analyzing process route and binding function, the whole structural scheme was made out through first decom- posing and then integrating basic functions. A single nonel was rolled and 10 nonels were strapped. Winding and rolling were realized by rotating parts. Delivery of a single nonel and strapping of 10 nonels were realized by direct driven pneumatic elements. Adhesive tape was used as strapping material to strap the 2 positions after rolling. Design and man- ufacturing of binding machine for plastic nonel were finished through trial-manufacture, improvement and actual produc- tion assessment for 2 prototypes. The productivity of the machine was 700 bales/8 h which achieved the design objectives and requirements. In conclusion, the desig