MSS SP-43-2008 锻制不锈钢对焊管件.pdfVIP

MSS SP-43 -2008 Wrought and Fabricated Butt-Welding Fittings for Low Pressure, Corrosion Resistant Applications Standard Practice Developed and Approved by the Manufacturers Standardization Society of the Valve and Fittings Industry, Inc. 127 Park Street, NE Vienna, Virginia 22180 Phone: (703) 281-6613 Fax : (703) 281-6671 Email: info@ MSS STANDARD PRACTICE SP-43 This MSS Standard Practice was developed under the consensus of the MSS Technical Committee 113 and the MSS Coordinating Committee. The content of this Standard Practice is the result of the efforts of competent and concerned volunteers to provide an effective, clear, and non-exclusive specification that will benefit the industry as a whole. This MSS Standard Practice is intended as a basis for common practice by the manufacturer, the user, and the general public. The existence of an MSS Standard Practice does not in itself preclude the manufacture, sale, or use of products not conforming to the Standard Practice. Mandatory conformance is established only by reference in a code, specification, sales contract, or public law, as applicable. Unless otherwise specifically noted in this MSS SP, any standard referred to herein is identified by the date of issue that was applicable to the referenced standard(s) at the date of issue of this MSS SP. (See Annex A). This document has been substantially revised from the previous 1991 (R 2001) edition. It is suggested that if the user is interested in knowing what changes have been made, that direct bycompari