基于应变测量的液体动态称重技术研究-机械工程专业论文.docxVIP

AbstractSubject： Abstract Subject： Study of Liquid Dynamic Weighing Technology Based on Strain Measurment Special ity：Mechanical Engineering Name：Zhang li Signature： Supervisor：Pore．Gao zonghai Signature： Abstract What thi ssay researches is raised under the background that the tcchnology the dynamic weighing things is not complete and good．It is about how to solye the problem through the technology of software，and by using the maths mould in the measuring system． This essay expounds the feature of weighing dynamic things，and it is research determining the qllality of weighing， using non—linear -parameter—way to reach high-speed．continueus and accurate mcasuring． Through analysis the process of pouring liquid，a dynamic maths mould is set up．Through analysi the response of the dynamic mouId under the impetus of impulse， corresponding mould is developed． According to the supposing that clIntinuou pouring in short time equal the impact each unit。firstlY，a spending system of mollld is developed．Through analysis the theoretical dctail from calclllation and exPeriment．in the way of non一1ineal—Parameter．the feasibilitY of this methed is delllonstrated．0n this basis，a distinguishing maths menld is developed，and it is demonstrated that it is efeective to the corresponding calculated results while it has quite difference to the resuIts of experimental details，so it not be applied in practice．0El the contrary，the di stingui shing by using unit quality corresponding mould applies completely to the experimentai details of continuous Pouring 1iquid．So this methed is recommended to be used the distinguishing method of the Pouring—liquid-weighing—system． Dllrillg the analysis on the experimental details，it is found that it is not enough to just consider the innate one—way frequency of the system，and that the ellergy of transverse frequency of the weighing systern and of the measuring systern is greater than that of the spring vibration．So it is unfavorable for