钢管三辊斜轧空心减径过程研究-精密成形工程.PDF

第5卷摇 第3期 摇 摇 摇 摇 摇 摇 精 密 成 形 工 程 摇 摇 2013年5月 JOURNAL OF NETSHAPE FORMING ENGINEERING 摇摇摇 55 钢管三辊斜轧空心减径过程研究 1 2 2 3 王召林 ,秦建平 ,朱洪志 ,贾尚武 (1.太原科技大学 机电工程学院,太原030024; 2.太原科技大学 材料科学与工程学院,太原030024; 3.中国重型机械研究院股份公司,西安710032) 摘要:借助有限元分析软件ANSYS/ LS鄄DYNA,研究钢管三辊斜轧空心减径过程中送进角与钢管变形状 况,尤其是与壁厚的关系。 试图通过分析不同送进角的条件下,轧件变形区内应力鄄应变分布,壁厚变化规律 及轧制后毛管端面形状,确定钢管斜轧空心减径的可行性和有效性。 关键词:斜轧;送进角;空心减径;有限元 DOI:10.3969/ j.issn.1674鄄6457.2013.03.013 中图分类号:TG335.7摇 摇 摇 文献标识码:A摇 摇 摇 摇 摇 文章编号:1674鄄6457(2013)03鄄0055鄄04 Research based on the Feed Angle at the Three鄄roll Cross Rolling Hollow Reducing Process 1 2 2 3 WANGZhao鄄lin ,QIN Jian鄄ping ,ZHUHong鄄zhi ,JIA Shang鄄wu (1.College of Electrical and Mechanical Engineering,Taiyuan University of Science Technology,Taiyuan030024,China; 2.College of Materials Science and Engineering,Taiyuan University of Science and Technology,Taiyuan030024,China; 3.China National Heavy Machinery Research Institute AG,Xi爷an710032,China) Abstract:WiththefiniteelementanalysissoftwareANSYS/ LS鄄DYNAthefeedangleandsteelpipedeformationinthree鄄rollcross rolling hollow reducing processwere studied,especially withthewall thickness. An attemptwasmadethroughthe analysisof theroll鄄 ing deformation region stress鄄strain distribution,wall thickness variation and the shape of the pipe blank endface under different feed angles to determine thefeasibility and effectiveness of cross rolling hollow reducing process. Key words:cross rollin