汽车专业英语课件1文档资料.pptVIP

Company Logo 2.3. Different ABS systems - Bosch ABS 2 Bosch ABS 2 is an add-on system which is built on to a conventional brake system. The electronic control module is position separately or integrated in with the hydraulic modulator. The system consisted of: ? Electronic control module;  ? 4 wheel sensors;  ? A hydraulic modulator;  ? A brake switch;  ? ABS warning light. add-on system 附加系统 module/5mCdju:l/ 模块 brake switch 制动开关 Company Logo 2.3.1. Different ABS systems - Bosch ABS 2 - EBCM The electronic brake control module (EBCM) is either an integrated part of the modulator or remote located. The module receives signal from wheel speed sensors. Based on the signals, speed, acceleration, and acceleration of the wheels are continually monitored. And a reference speed and tendency to a wheel lock up calculate by the unit. Two identical microprocessors with identical program structures. It is assumed that there is an error in the system if the input information does not fall within the specifications or if the output commands differ during the cross check. When the ignitions turned on, the control module runs a self-check. If a fault is detected the ABS function will be shut down. reference speed 参考车速 ignition /i^5niFEn/ 点火开关 self-check 自校验 function ~ shut down Company Logo 2.3.2. Different ABS systems - Bosch ABS 2 - Function Phase 1, Pressure increase: This is the normal position of the valve for non-ABS braking and during the pressure increase phase of ABS braking. The EBCM is passive, and does not energize the solenoid valve, if there is no indication the wheel lock. This position directly connects the master cylinder and wheel circuit, Master cylinder pressure applies to the wheel circuit. solenoid /‘s?ul?n?id/ 电磁螺线管（线圈） Pressure ~ increase ??decrease Company Logo 2.3.3. Different ABS systems - Bosch ABS 2 - Function Phase 2, Pressure maintain: When the wheel sensor signal indicates excessive deceleration, the electronic brake control mo