国产600MW汽轮机单顺阀滑压运行轴承特性试验研究.PDF

国产600MW 汽轮机单顺阀滑压运行轴承特性 试验研究 田 丰 邓少翔 韩景复 徐 睿 郑李坤 （广东电网公司电力科学研究院，广东广州 510600 ） Experimental study on sliding pressure operation characteristics of bearing under single valve and sequence valve in a domestic made 600MW turbine TIAN Feng DENG Shao-xiang HAN Jing-fu XU Rui ZHENG Li-kun (Power Research Institute of Guangdong Power Grid Corporation, Guangzhou 510600, China) Abstract: The experimental research on sliding pressure characteristics of bearing in a domestic made 600MW turbine operation under single valve and sequence valve steam admission mode was performed based on field test. Result shows, operation under sequence valve mode compared with single valve mode, turbine positive pad of thrust bearing, support bearing return oil temperature is high general, at the same time, temperature change of support bearing No.1 No.2 pad present different feature. Since admission balance steam, it is little to make the support bearing temperature change with load. The research result of this paper for develop related work further establish foundation. Key words: single valve; sequence valve; sliding pressure operation; characteristics of bearing; domestic made 600MW units; steam turbine 摘 要：基于现场试验，对某国产600MW 汽轮机分别在单阀和顺序阀运行模式下滑压运行轴承特性进行了研究。结果 表明，顺阀方式运行推力轴瓦正面温度、支持轴承回油温度普遍较单阀模式高，支持轴承该 1、2 号瓦块温度变化呈现 不同特征。单阀模式与顺阀模式相比，由于配汽均衡，使支持轴承瓦块温度变化随负荷变化小。文章的研究结果对进一 步开展相关工作打下基础。 关键词：单阀；顺序阀；滑压运行；轴承特性；国产600MW 机组；汽轮机 中图分类号： 文献标识码：A 文章编号： 0 引言 机组一直存在单阀模式切换为顺序阀困难的问 题，为此，对该机配汽特性对各参数的影响进行 目前大型汽轮机DEH 都具备阀门管理功能， 了全面试验研究。在综合分析配汽特性对轴承金 机组设计可实现“单阀”和“顺阀”运行。不同 属温度、振动水平等影响的基础上，对DEH 逻辑 的配汽运行方式对机组的安全、经济性有显著影