胶印机中印刷压力分布的有限元仿真-包装工程.PDF

第39 卷 第 17 期 包 装 工 程 2018 年9 月 PACKAGING ENGINEERING ·203 · 胶印机中印刷压力分布的有限元仿真 李文威 1 ，陈南 2 （1.华南智能机器人创新研究院，佛山 528315 ；2.东南大学，南京 211189 ） 摘要： 目的 揭示胶印机中印刷压力分布的函数规律，为胶印机设计和印刷质量控制提供参考依据。方 法 选用Mooney-Rivlin 模型作为橡胶材料本构模型，在MSC.Patran 中建立胶印机印刷滚筒与橡胶层接 触挤压的有限元仿真模型。以MSC.Marc 为求解器，对有限元模型进行集材料非线性、几何非线性和边 界条件非线性等 3 种因素于一体的有限元分析。利用最小二乘法拟合有限元节点处的接触应力计算结 果。结果 经过计算，某型胶印机的平均印刷压力为0.548~0.643 MPa 。结论 在压印接触区域中，橡胶 层外表面法向接触应力的分布函数为高斯函数，且平均印刷压力可通过高斯函数的二重积分求出。 关键词：胶印机；印刷压力；有限元分析；橡胶材料；非线性；最小二乘拟合 中图分类号：TS803.6 文献标识码：A 文章编号： 1001-3563(2018)17-0203-05 DOI ：10.19554/j.cnki.1001-3563.2018.17.034 Finite Element Simulation for Printing Pressure Distribution within Offset Press 1 2 LI Wen-wei , CHEN Nan (1.South China Robotics Innovation Research Institute, Foshan 528315, China; 2.Southeast University, Nanjing 211189, China) ABSTRACT: The work aims to unveil the distribution function law of the printing pressure within offset press to provide a reference basis for the offset press design and the printing quality control. Mooney-Rivlin model was taken as rubber material constitutive model, and the finite element model was established in MSC.Patran to simulate the contact between printing cylinder of offset press and rubber blanket. With MSC.Marc as the solver, the finite element analysis of the model was performed. The finite element analysis was integrated with three nonlinear factors, i.e. nonlinearity of material, ge- ometry and boundary conditions. The contact stress calculations at the finite element nodes were fitted by the least square method. By calculation, t