基于MPPT控制的光伏发电系统设计_毕业设计(论文).doc

前言 基于MPPT控制的光伏发电系统设计 洛阳理工学院毕业设计（论文） PAGE I 基于MPPT控制的独立光伏发电系统设计 摘 要 随着时代的发展，人类对能源的需求越来越多，新能源开发是解决能源问题的根本途径，而太阳能光伏发电正是新能源和可再生能源的重要组成部分。 本文主要研究独立光伏发电系统，它有着相当广泛的应用。独立光伏系统主要包括了光伏电池、蓄电池组、充电器和逆变器四个组成部分，本文对独立光伏系统中的最大功率点跟踪进行深入研究。本文利用光伏电池的数学模型和等效电路，在MATLAB/Simulink中建立了光伏电池的仿真模型，得到了与实际光伏电池输出特性一致的仿真曲线，为进一步研究最大功率点跟踪打下了基础。最大功率点跟踪的方法有很多，但是应用最为广泛的是扰动观察法和电导增量法，本文对自适应占空比干扰法进行了详细的分析，给出了算法设计，并建立了光伏电池的仿真模型对算法进行了仿真，仿真结果验证了算法设计的正确。 关键词：独立光伏系统，光伏电池，最大功率点跟踪 The Design of Independent Photovoltaic Power Generation System Based on MPPT Control ABSTRACT With the development of economics and technology, more and more energy is required. Researching and developing new energy is the radical method to resolve the energy problem, and the solar energy is the important composing of the new energy and the renewable energy. Research on the stand-alone photovoltaic system is the main content of this thesis. There is very comprehensive application for the stand-alone photovoltaic system. The stand-alone photovoltaic system is composed of the solar cell, storage battery, charger and inverter. Several key techniques, for instance , the MPPT(Maximum Power Point Tracking) are deeply studied in this thesis. Base on the mathematical model and the equivalent circuit, the solar cell simulation model in MATLAB/Simulink is built in order to research the MPPT, and the curve which is in accordance with the actual solar cell is attained. This work built the base for the further research on MPPT. There are many methods for MPPT, but the PO(Perturb and Observe) method and the C.I. (Conductance incremental) method are applied most extensively, and these two methods are analyzed in detail. The algorithmic designs of the PO method and the C.I. method are given in this thesis, and the algorithmic designs are simulated with the model of the solar cell in MATLAB/Simulink, and the result of simulation validated the correctness of the design of the two algorithms. Besides, take the PO for instance, the factors which ca