冷柜门体生产线的排序问题研究-机械工程专业论文.docxVIP

广东工业大学硕士学位论文最后，以该冷柜公司门体生产线的实际问题作为案例进行分析，分别采用基本 广东工业大学硕士学位论文 最后，以该冷柜公司门体生产线的实际问题作为案例进行分析，分别采用基本 遗传算法和改进遗传算法对两个阶段的排序方案进行求解。最后结果表明，改进遗 传算法优于基本遗传算法，并证明了本文所研究方法的可行性，有效地提高了该企 业的生产效率，避免了资源浪费。 关键词：混流装配线；排序；遗传算法；改进遗传算法；库存量计算算法 II 万方数据 AbstractAbstract Abstract Abstract With the increasing of global market competition and the development of personalized customer requirements，manufacturing enterprises have to ensure that products of high quality and production of low cost，and guarantee to satisfy the personalized needs of customers in the shortest possible time．So，the production paUern of enterprise transform from the traditional mass production mode to multiple varieties and small batch production mode，the assembly line of traditional single varieties gradually replaced by the mixed flow assembly line of multiple varieties．Among them， the reasonable production sequencing of mixed flow assembly line is one of the effective ways to improve the efficiency of mixed flow assembly line，and it has the vital significance for the enterprise in market competition． This paper applies an freezer door production line of a freezer company as an object，studies with the foaming mould constraints of mixed flow production line sequencing problems．This production line consists of two parts，with pre-assembly line and foaming line．Among them，the pre—assembly line complete the assembly of the parts of a door，the foaming line complete the filling of door body heat preservation and heat insulation layer．Due to the constraints of mold type and mold number of foaming line，in the case of mixed flow production，sequencing of production in the pre-assembly line and sequencing of mould in the foaming line directly affect the matching rate of product model and foaming mould model in the process of production，which affect the number of empty foaming mould and the number of average work-in—process inventory Therefore，this paper optimize the sequencing of mixed flow line production of pre。assembly line and foa