汽车电子助力转向ppt精编版.pptVIP

* 优点: 最大可减少85%的转向力 节省燃油 没有污染的风险 * Total rack force: Drive and servo total 9000 N. 所有黑色的元件可以更换 电机和控制单元也可以个别更换，但现在不考虑 * 核心是带有双齿的转向齿条。方向盘和转向齿条直接是机械连接，就是说如果电机有故障，机械部分依然可以工作。 * * During average use, the power draw is 2.5 A, max. 80 A (100 A can also be achieved for short periods). * Efficient cooling is achieved due to the closely connected control unit and servo. However, if the temperature at the end stages exceeds 100 °C, the factor continuously reduces! Indicator lamp K161 comes on from a factor of 60 %! * Operating diagram can be adapted to the vehicle (depending on engine or weight). * 如果 更换G85或ESP控制单元 J104, G85进行零点平衡，J104必需重新编码。 (See “Guided Trouble Shooting“) * * * 宝来ESP内圈等分60份，因此不能识别出转过整圈之后的差别，所以需要整圈计数器， 速腾的传感器内圈分为五块，但每块间距不同，所以可以快速识别出转角变化以及可以记忆转过的圈数。 另外配合上外圈不仅可以识别出转动的角度，而且可以识别出转动的速度，另外还可以记忆初始位置。 * Steering torque sensor G269 records the twist and communicates the determined steering torque to control unit J500. The return torque is not sufficient during driving operation to turn the wheels back to the straight-ahead position. This situation is detected by the J500 via the G85. By evaluating steering torque, vehicle speed, engine speed, steering angle and the characteristic curve stored in the control unit, the control unit calculates the torque of the motor required for resetting. The maximum support, however, is limited to 25 Nm. * * Indicator lamp K161 switches at steering support 60 %! Soft switch-off: Reduced steering ratio does not switch off abruptly. Switch-off is effected in ramp form, so as not to confuse the driver. * The characteristic curve can be activated in Technical Support using the VAS 5051 tester, Function 10 – Adapt“. This is required if a control unit is being replaced, for example. (For detailed information, see latest Repair Handbook and “Guided Trouble Shooting“) * * * EPS Electric Power Steering 双齿轮电动助力转向系统 See Notes 方向盘 - 带方向盘转角传感器G85的转向柱控制单元 - 转向柱 - 转向力矩传感器 G269 - 转向齿轮 - 电子机械助力转向电机V187 - 助力转向控制单元 J500 没有转向助力油，减少对环境的污染 “