外文翻译--基于级进模冲压工艺规划的黑板架构（有word版）.docVIP

Int J Adv Manuf Technol (2005) 26: 774-783 DOI 10.1007/s00170-003-2037-8 ORIGINAL ARTICLE S.B. Tor ? G.A. Britton ? W.Y. Zhang A knowledge-based blackboard framework for stamping process planning in progressive die design Received: 3 October 2003 / Accepted: 21 November 2003 / Published online: 1 December 2004 ? Springer-Verlag London Limited 2004 Abstract It is widely accepted that stamping process planning for the strip layout is a key task in progressive die design. However, stamping process planning is more of an art rather than a science. This is in spite of recent advances in the field of artificial intelligence, which have achieved a lot of success in incorporating built-in intelligence and applying diverse knowledge to solving this kind of problem. The main difficulty is that existing knowledge-based expert systems for stamping process planning lack a proper architecture for organizing heterogeneous knowledge sources (KSs) in a cooperative decision making environment. This paper presents a knowledge-based blackboard framework for stamping process planning. The proposed approach speeds up the progressive die design process by automating the strip layout design. An example is included to show the effectiveness of the proposed approach. Keywords Blackboard framework ? Graph-based ? Knowledge-based ? Object-oriented ? Progressive die design ? Stamping process planning Introduction Progressive dies for producing sheet metal parts in mass production have been widely applied in various industries such S.B. Tor (S) Singapore-MIT Alliance, SMA-NTU Office, School of Mechanical Production and Engineering, Nanyang Technological University, 50 Nanyang Avenue, Singapore, 639798 E-mail: msbtor@ntu.edu.sg Tel.: +65Fax: +65G.A. Britton School of Mechanical and Production Engineering, Nanyang Technological University, 50 Nanyang Avenue, Singapore 639798 W.Y. Zhang Artificial Intelligence Institute, College of Computer Science, Zhejiang University,