187-弧肋隔板逆流露点蒸发冷却器性能研究.pdf

弧肋隔板逆流露点蒸发冷却器性能研究1 郑州轻工业学院能源与动力工程学院 王于曹 吴学红 王燕令 龚毅 摘要：本文设计了一种新型露点蒸发冷却器，研究了外界工况、进气速度比、冷却水温 度、弧肋间距、弧肋弦长对其冷却效率的影响。研究结果表明，在研究范围内，工作气体与 产出气体进气速度比为1.5 时冷却效率最大，达到126.24%；弧肋间距和弧肋弦长对冷却效 率影响显著，分别在5mm、15mm 时达到最大；冷却效率随冷却水循环温度的升高而降低；通 过与传统结构对比，新型露点蒸发冷却器冷却效率分别在进气温度、环境湿度、进气速度条 件下最大提升了10.32%、25.82%、13.87%。 关键词：弧肋；蒸发冷却；冷却效率；露点间接蒸发冷却器 Performance of Counter Flow Dew-point Indirect Evaporative Cooler of Arc Rib School of Energy and Power Engineering, Zhengzhou University of Light Industry Wang Yucao Wu Xuehong Wang Yanling Gong Yi Abstract: In this paper, a new type of dew-point evaporative cooler is designed, the effects of external working conditions, inlet air velocity ratio, cooling water temperature, arc rib spacing, and arc rib chord length on cooling efficiency are studied. The results show that, the cooling efficiency is the highest when the ratio of the working air to the produced air inlet velocity is 1.5, reaching 126.24%;the arc rib spacing and arc rib chord length have significant effects on cooling efficiency, reaching maximum at 5mm and 15mm respectively. The cooling efficiency decreases with the increase of cooling water temperature. Compared with the traditional structure, the cooling efficiency of the new type of dew-point evaporative cooler is increased by 10.32%, 25.82%, and 13.87% under the conditions of air inlet temperature, ambient humidity, and air inlet velocity respectively. Keywords: arc rib; evaporative cooling; cooling efficiency; dew point indirect evaporative cooler 1 引言 经济和社会的快速发展加剧了能源的消耗，据相关数据统计建筑能耗约占社会总能耗的1/3， 而空调能耗又约占建筑能耗的2/3[1, 2] [3, 4] ，我国2010 年人均碳排放已超世界平均水平 ，国家“十 三五”规划提出增加可再生能源的比重，对于暖通行业，开发新型节能空调系统以降低空调能耗 已成为发展趋势之一。 基金项目：国家自然科学基金资助项目）；河南省杰出青年基金项目(154100510014) ；河南省教 育厅创新团队项目（17IRTSTHN029）。