电镀测试和检查标准的检测程序.docxVIP

Standard Practice Procedures for Test Inspection of the Plating 电镀测试和检查标准的检测程序 Scope 范围 This document specifies the Engineering Requirements Specifications to be conducted at OQC for all Spring Contacts with plating. Unless otherwise noted, these tests shall be applied to finished springs at the plating supplier or spring supplier site prior to shipment to customer. The customer is permitted to conduct any or all of the tests requirements at their IQC to the sampling frequencies defined in this document and is obligated to reject the lot if any test fails the requirement. 本文件适用于成品出货检验所有弹簧片接触面的电镀技术要求规格, 文件中定义了客户允许进行的任何或所有的测试要求，除非另有说明，否则在出货给弹簧客户之前，电镀供应商或者弹簧供应商都必须完成这些测试，若有任何测试失败不合要求项，客户IQC在取样频率中有责任判定为不合格Lot。 The quality of the part should not be degraded by assembly, molding, or processing into the final unit, so springs from disassembled units must also pass the test requirements specified in this document, unless otherwise noted. 为降低后序装配，注塑或最后加工成成品的部分质量，所以本文件规定了弹簧从拆开的产品就必须通过这些测试的要求，除另有注释外。 The failure modes of concern include but are not limited to the following. 重要的失效模式包括但不仅限于以下内容： Delamination of the plating layer from the basis metal 镀层的起皮 Discoloration of the plated layer 电镀层变色 Damage to the spring 铁片损坏 Corrosion of the plated layers 电镀层防腐蚀 Evidence of increase porosity 针孔的判定 The tests are to be conducted at the sampling frequencies defined in this document. All samples tested must pass prior to shipping the lot and to be accepted at the customer site. 本文件定义采样频率测试，所有样品测试在出货之前必须全部通过且被客户所接受。 Thickness measurement (X-ray) X-Ray厚度测量 Salt mist test 盐雾测试 Heat quench test 热处理测试（热冲击） Tin plating soldering test 镀锡表面可焊性测试 Adhesive test 胶粘剂剥离测试（结合力测试） Bending test 可弯曲测试 Nitric acid Test 耐腐蚀性测试 OQC Test Requirements OQC 测试要求 Unless otherwise noted, the samples must meet all functional requirements specified in the ERS. 除另有说明，样品必须满足ERS规定的所有功能性需求。 1. Thickness Measurement 厚度测量 A. Plating Thickness Specification: 镀层厚度规格说明 Plating thickness is specified in the part d