多相流体模型应用的范围.docVIP

多相流体模型应用的范围 版权：Bharath Rao 1998年5月18日 目录 Duns和活性氧相关 Hagedorn和棕色的相关 Orkiszewski相关 Beggs和布里尔相关 一般建议 参考资料 摘要 Four multiphase flow models or correlations (Duns Ros, Hagedorn Brown, Orkiszewski, and Beggs Brill) are currently available in Hydrafor predicting the pressure profile in a well. The range of applicability of the multiphase flow models is dependent on several factors such as, tubing size or diameter, oil gravity, gas-liquid ratio, and, two-phase flow with or without water-cut. The effect of each of these factors on estimating the pressure profile in a well is discussed separately for all the multiphase models considered. A reasonably good performance of the multiphase flow models, within the context of this document, is considered to have a relative error (between the measured and predicted values of the pressure profile) less than or equal to 20%. 四多相流体模型或相关性(Duns和活性氧,Hagedorn Brown,Orkiszewski,Beggs和布里尔)目前供应Hydrafor预测其压力剖面在一口井里。标准的适用范围的多相流体模型是取决于几个因素,如、油管大小或直径、石油地心引力,气液比,两相流有或没有water-cut。效果每个这些因素的估算压力剖面问题分别井为所有的多相模型考虑。一个合理可靠的性能模型,研究多相流动的上下文以内这个文件,可以被认为是两个人之间的相对误差测量与预测值进行压力剖面)小于或等于20%。 Duns Ros Corre-lation The Duns Ros correlation is developed for vertical flow of gas and liquid mixtures in wells. This correlation is valid for a wide range of oil and gas mixtures and flow regimes. Although the correlation is intended for use with .dry. oil/gas mixtures, it can also be applicable to wet mixtures with a suitable correction. For water contents less than 10%, the Duns-Ros correlation (with a correction factor) has been reported to work well in the bubble, slug (plug), and froth regions. The pressure profile prediction performance of the Duns Ros method is outlined below in relation to the several flow variables considered: Duns和活性氧的相关,设计开发了垂直流动混合物气体或液体在威尔斯。这种关系是有效的广泛的油气混合物和流量变化。虽然相关是专为使用与.dry.油气混合物,它也可以适用于湿混合物和适合的修正。为水份含量低于10%,Duns-Ros相关(修正系数)被报道来合作得很好,这一泡沫的时候,塞(塞),泡沫地区。压力剖面的预测性能的方法Duns和活性氧简述以下与几个流量不同考虑: Tubing Size. In general, the pressure drop is seen to