1MW CSP-ORC电站储能方案分析.pdf

ANALYSIS OF THERMAL ENERGY STORAGE SOLUTIONS FOR A 1 MW CSP-ORC POWER PLANT David Sánchez, Hicham Frej, Gonzalo S. Martínez, José María Rodríguez, El Ghali Bennouna 3rd International Seminar on ORC Power Systems, October 12-14, 2015, Brussels, Belgium Content Introduction Methodology CSP-ORC plant description Thermodynamics of heat storage Potential storage configurations for CSP Thermal storage technologies Results Daily simulation results Overall technologies comparison Conclusions Introduction Why a Solar-ORC System? • Applicable to medium size power plants (5MW); • Not much capital intensive, faster to deploy; • Simpler than conventional steam cycle; • Low pressure/ low cost piping; • Firmer dispachability than PV; SOLTIGUA Linear Fresnel Collector • Good part-load generation application… Why a Thermal Storage System? • Increased power production; • Lower LCOE (electricity generation cost); • Possible production extension to night time; • more stable heat supply… EXERGY radial outflow turbine Methodology: CSP-ORC plant description Gross Power Output: 1 MWe Estimated Production: 1,5 GWh/yr (DNI Benguerir: 2100 kWh/m²/y) Land usage: ~2.5 Hectares without storage, ~3.5 Hectares for with storage. Classical steam- CSP-ORC CSP Solar technology PTC collectors Linear Fresnel d k r Cooling medium Water Air l Heat transfer c Working Fluid: i Cooling